Rénovation d’un Tanzer 26 par Martial Harvey

Tanzer 26 upgrading by Martial Harvey

 
Homepageindex.htmlshapeimage_2_link_0
Upgrading your TanzerUpgrade_your_Tanzer.htmlshapeimage_3_link_0



(1) Table escamotable recouverte de formica. (2) Caisses de son. (3) La cloison est recouverte de tapisserie ( 4 ans sans dommage). (4) Table à carte en formica. (5) Panneaux coulissants en Plexi tribord-babord. 

(1) Folding table finished in formica. (2) Speaker Boxes. (3) Main bulkhead covered with wallpaper (still looks good after 4 years). (4) Chart table finished in formica. (5) Sliding plexiglass doors on port and starboard. 



 

(1) Armoires en contre-plaqué 1/2" recouvertes de formica. (2) Tiroirs sous la descente. (3) Hublot fabrication maison. 

(1)Lockers made with 1/2 plywood - finished in formica. (2) Drawers under the companionway. (3) Home made portlight. 



Vous remarquerez que j'ai coupé la petite cloison embarrassante entre la table à carte et le comptoir, et repeint tous les bois en gris. Cela donne un effet de grandeur dans la cabine. 

Note that I have cut away that annoying divider between the counter and the settee. I painted all the wood grey which gives the effect of a spacious cabin. 


 

Une roue et un siège pour le barreur sur le Tanzer 26. 

A wheel and helmsman's seat on the Tanzer 26

 par Martial Harvey, T26 #318, "Le Fou du Large" 

Alma, Québec, lac St-Jean.  © Martial Harvey, 1998.

 





Projet : Plans de hale-bas par Martial Harvey.

J'ai construit un hale-bas rigide (air-pressurisé) pour mon T-26. J'ai terminé la fabrication et j'ai fait quelques essais. Mon hale-bas fonctionne à merveille par tous les temps et les materiaux que j'ai employés semblent assez fort pour faire le travail. J'ai navigué par petit temps, par temps moyen, par gros temps (25 - 30 kns) et tout à résisté. Cependant je me dégage de toute responsabilité pour la résistance des matériaux employés et de tout dommages qui pourraient survenir autant à la personne qu'au matériel suite à un bris de ce Hale-Bas.
[ Voir les photos plus bas.. ]

  - Martial Harvey, T26 #318, "Le Fou du Large"

Plan du hale bas   

(Vous pouvez sauvegarder les plans sur votre 

disque dur ou les imprimer pour référence future.) 

 




Project: Boom vang plans by Martial Harvey. 

I have constructed an air pressurized boom vang for my Tanzer 26, and have had the opportunity to try it out on several occasions. The boon vang works marvellously in all types of weather, and the material I have selected for its construction appears to be strong enough for the job. I have used it in light winds, average wind conditions, and strong (25 to 30 knots) winds, and everything held up fine. However, I disclaim all responsibility for the material strength used in this project and for all damage or injury to the boat or persons resulting from the failure of this boom vang. [ See below for photos. ]

  - Martial Harvey, T26 #318, "Le Fou du Large"

Boom vang plans   

(You may wish to save the plans on your hard 

disk or print them for future reference.)



Photos: projet de hale-bas / Boom vang project.





 
Homepageindex.htmlshapeimage_4_link_0
InformationInformation.htmlshapeimage_5_link_0